Skip to content
FitsIntermediate6 min

Hinges and print-in-place joints

Find the gap your printer needs for moving parts, then add hinges and joints that print already put together and swing instead of fusing.

Guide 15 of 16See all guides
Jump to section
  1. 1Print the Moving parts test
  2. 2Tap the first one that swings
  3. 3Add a hinge
  4. 4Follow the joint rules
The Tools window listing the Fit test, Thread fit test, Moving parts test, Press-fit test, Overhang test and Bridging test

Print the Moving parts test

Choose Tools on the left and pick Moving parts test: six small hinges that print already put together, each with a bigger gap. Export just that test and print it with the filament you use most.

Tap the first one that swings

Bend each hinge, smallest gap first, and tap the first one that swings freely all the way. That’s your moving-parts gap. New hinges from the parts library start with it.

Add a hinge

Choose Parts, search “hinge”, and place the adjustable hinge. Its sliders set the size, and it’s free on every plan.

Follow the joint rules

Keep the gap on every side of a moving part, point pins up and down when you can, use 45° cones when a pin has to lie down, and never bridge flat over a moving part. The print-in-place joints page explains each one.

Tip: Even the biggest gap stuck? Check your first layer. A squashed first layer welds joints together at the bottom.

Was this guide helpful?
Ask Nook