Skip to content
Moving parts

Print-in-place joints that actually move.

Flexi dragons, hinged boxes and posable figures all come down to one number: the gap between the moving parts. Too small and the joint fuses solid. Too big and it flops. Find your printer’s gap once and design every joint around it.

The Tools window listing the Fit test, Thread fit test, Moving parts test, Press-fit test, Overhang test and Bridging test
Step 1 · Free

Find the gap your printer needs

Every printer, nozzle and filament squeezes plastic a little differently, so there’s no single right gap. The Moving parts test in the studio’s Tools prints six small hinges already put together, each with a bigger gap, starting at 0.2 mm.

  1. Choose Tools on the left, pick Moving parts test, and export just that test.
  2. Print it with the filament and settings you use most.
  3. Bend each hinge, smallest gap first, and tap the number of the first one that swings freely all the way.

That’s your moving-parts gap. New hinges from the parts library start with it, so the next hinge you drop in already fits your printer.

Even hinge 6 stuck? Check your first layer. A squashed first layer (elephant’s foot) welds the bottom of a joint to its neighbor. Leave the first layer of a joint open, or lift the moving part 0.2 mm off the bed.
Step 2

Design rules for joints that print in place

  • Keep the gap on every side of the moving part, including above and below, not only around the pin.
  • Point hinge pins up and down when you can. A pin printed standing up comes out round; one lying down prints as a stack of layers and grips.
  • Use cone-shaped pins and sockets when a pin has to lie down. A 45° cone prints without supports and still holds the joint together.
  • Don’t bridge over a moving part. A flat roof over a gap sags into it and glues the joint. Slope it at 45° instead.
  • Give joints some meat. Walls around a pin at least 1.2 mm thick (three nozzle widths) survive being bent a hundred times.
  • Break joints free gently after printing, working each one back and forth before you play with it.
Step 3

Pick the right kind of joint

LIDS, BOXES, DOORS

Hinge

Search hinge in Parts. The adjustable hinge has sliders for its size and is free on every plan. It starts with your moving-parts gap.

FLEXI TOYS

Chain of segments

A body made of short segments, each linked to the next by a pin and socket that turns one way. Design one segment, copy it along the body, and shrink each copy a little toward the tail.

POSABLE FIGURES

Snap fit

Great for hips and shoulders that need friction to hold a pose. Print a test joint first: a change of 0.1 to 0.2 mm in clearance makes a big difference.

SWAPPABLE PARTS

Magnets

Best for heads, hands and accessories. Run the free Press-fit test for your magnet size and holes made for magnets match your printer. Mark the polarity before gluing.

Coming next: a print-in-place joint maker that sizes pins, sockets and gaps from your moving-parts test in one step. It’s on the Roadmap.

Questions about moving parts

What gap should a print-in-place hinge have?

It depends on your printer, nozzle and filament, which is why the Moving parts test exists. Its six hinges start at 0.2 mm; the first one that swings freely is your gap.

Why did my flexi toy print as one solid piece?

The gap was too small for your printer, or the first layer was squashed and welded the joints at the bottom. Run the Moving parts test and check your first layer.

Snap fit or magnets?

Snap fits for joints that need friction to hold a pose, magnets for parts you want to swap. Many figures use both.

Do I need supports for joints?

Not if pins stand up or use 45° cones and nothing flat bridges over a moving part.

One test. Every hinge fits.

Start designing free
Ask Nook