Skip to content
Help center GuidesPrinting
PrintingBeginner6 min

Tune it to your printer

Six small free tests you print once. Tap the number that came out best, and holes, nuts, hinges, magnet pockets and the overhang check match your printer.

Guide 11 of 16See all guides
Jump to section
  1. 1Open Tools
  2. 2Fit test
  3. 3Thread fit test
  4. 4Moving parts test
  5. 5Press-fit test
  6. 6Overhang test
  7. 7Bridging test
The Tools window in the studio listing the Fit test, Thread fit test, Moving parts test, Press-fit test, Overhang test and Bridging test

Open Tools

Choose Tools on the left, under Parts and AI. Every test is free on every plan. Pick one, choose Put the test on the mat, then Export the test to export just that test.

Fit test

A plate with six numbered holes, each a little bigger than the last, and a 5 mm peg. Push the peg into each hole, smallest first, and tap the first one it slides into without forcing. That sets your fit allowance, which fitted holes and parts that slide together use.

Thread fit test

An M10 bolt and a block with six numbered nuts, each thread a little roomier. Screw the bolt into each nut by hand and tap the first one it turns all the way through smoothly. Nuts and threaded holes from the parts library use it. A bought steel M10 bolt works too.

Moving parts test

Six small hinges that print already put together, each with a bigger gap. Bend each one and tap the first that swings freely. New hinges from Parts start with that gap.

Press-fit test

Pick the magnet or bearing you use, and the test has six pockets sized for it. Push it into each pocket and tap the first one it goes all the way into by thumb and stays in when you turn the block over. Holes made for magnets and bearings use it.

Overhang test

Six fins, each leaning further over, from 45° to 70°. Look under them and tap the last one that came out clean. With ShapeNook Plus, the Overhangs view then shows only the overhangs your printer can’t manage.

Bridging test

Six bridges across two posts, from 10 to 60 mm long. Tap the longest one that came out flat, so you know how far your printer can print across open air without supports.

Tip: Print the tests with the filament and settings you use most. New printer, new nozzle or a different filament? Run them again.

Was this guide helpful?
Ask Nook